JOINTS CARDAN «G» SERIES WITH SLIDING BUSHES

- for middle-low speeds and where there are shock loads
- maximum working angle 45°
- maximum rotation speed 1000 rpm
- Special executions on request

Joints are available in 2 versions:
- G version to DIN 808
- GB version to DIN 808/7551

JOINTS CARDAN «H» SERIES WITH NEEDLE ROLLER BEARING

- for high speeds and relatively low torques
- maximum working angle 45°
- maximum rotation speed 4000 rpm
- Special executions on request

Joints are available in 2 versions:
- H version to DIN 808
- HB version to DIN 808/7551

They all consist of a star wheel core and 2 half joints with fork ends. Between the pins of the star wheel and the holes of the forks, 4 wear resistant sliding bushes (for G series) or roller bearings (for H series high speed) are fitted in.
Neither lubrication nor maintenance is required for H series (high speed joints with roller bearings) as their bearings are lubricated for life.
Joints with plain bearings G series are for middle-low speeds and where there are shock loads.
For high speeds and relatively low torques types with roller bearings (H - HB) are recommended.
Both versions offer high efficiency, silent running, low friction coefficient at competitive prices.
All rubbing surfaces are hardened and ground.
Maximum working angle is 45° for single joints and 90° for double joints.
Maximum rotation speed is 1000 rpm for G series, while H series can reach 4000 rpm.
All these joints are also supplied in telescopic version.